OIL COOLERS
HydroCool™ oil coolers reduce hot oil odors, bounce, chatter and leveling problems caused by overheated hydraulic fluid.
MORE ABOUT OUR OIL COOLER
Mount the oil cooler on the tank, wall or floor. Remote mounting is also available up to 110’ horizontally or 55' vertically. This allows the unit to be located in several locations and maintain proper functionality.
Labor with the HydroCool™ with average installation time taking approximately four hours for a two-man team for a normal project.
The cooler automatically turns on when the tank reaches 140ºF and automatically powers down when the hydraulic fluid has cooled to 100ºF, verifying the unit works only when it needs.
OIL COOLER BENEFITS
HydroCool™ oil coolers are compact and adaptable to work with all pump units. The oil cooler maintains oil integrity by pumping oil through a heat exchanger to cool and then returns the oil to the storage tank.
HYDRAULIC APPLICATIONS
HydroCool™ oil coolers are perfect for any hydraulic elevator with high usage. Some hydraulic applications in which the HydroCool™ is recommended are a twin-jack holeless with two- or three-stage telescopic jacks, heavily used single-stage twin jack holeless, and roped hydraulic applications with moderate use and travel exceeding 25 feet.
MORE BENEFITS
• Maintains oil integrity
• Extends pump unit system life
ADDITIONAL PRODUCT HIGHLIGHTS
TECHNICAL INFORMATION
HydroCool™ removes 17,500 BTUs per hour with the ability to pump eight gallons per minute. The HydroCool™ comes with an adjustable thermostat control to regulate the oil cooler.
Provide 120 VAC, 20A circuit.
The HydroCool™ weighs approximately 140 pounds and is 28" high by 24" wide by 17.5" deep.
The HydroCool™ can be mounted up to 110 feet horizontally and 55 feet vertically from the power unit. Piping, wiring and conduit to remote location are sold separately.
HYDROCOOL II™ bucket to “The HydroCool™ removes 17,500 BTUs per hour with the ability to pump eight gallons per minute. The HydroCool™ comes with a single motor that drives the fan and pump.
Provide 120 VAC, 20A circuit; fan motor FLA 3.4; pump motor FLA 6.6
The HydroCool II™ weighs approximately 125 pounds and is 20.5" high by 26" wide by 26" deep.
The HydroCool II™ can only be mounted adjacent to the reservoir.